Wheel Bearing + Bushes

for assembly work on torsion bar springs required when working on wheel bearings, supporting joints etc.

for circlips without holes on the wheel bearingsdisassembly of the retaining rings without special tools is almost impossibleduring wheel bearing replacement and chassis repairsuitable for: Citroen Saxo, Xsara, Xsara Break and Xsara Coupe Peugeot 106 II, 206, 206SW, 206 Plus, 306, 306 Break and 306 Cabrio Nissan Micra Renault Clio

for Renault Laguna IIfor convenient disassembly and assembly of rear axle box arrangement

also suitable for identically constructed VW LT vehiclesrequired when working on wheel bearings and stud axlesmanufactured from specialist steel

e.g. for bearing rings, bushings, etc.continuously adjustable for desired diameterno additional plates necessaryhexagon screw for fasteningsolid handle with knurling for perfect gripsolid striking surface ø 32 mm

to press and extract bearings, bushes etc.49 thrust plates: ø 18 - 65 mm (increasing by 1 mm each size), 74 mm1 receiver, can hold max. 2 thrust plates1 impact driveruse accessory thrust plate adapter No. 8752 (not included) to apply thrust plates with air hammer No. 8810also suitable for using in workshop press

to press and extract bearings, bushes etc.17 thrust plates: ø 70 - 150 mm (increasing by 5 mm each size)2 receivers, can hold max. 2 thrust plates1 impact driver1 hexagon key, 3 mmuse accessory thrust plate adapter No. 8752 (not included) to apply thrust plates with air hammer No. 8810also suitable for using in workshop press

to press and extract shafts, bearings etc.9 thrust plates, bore ø 14 mm, outer-ø: 40, 44, 50, 59, 63, 65, 72, 76, 81 mm1 punch